Cal-Van 467, Ford Ignition Module Wrench

This tool is used to remove and replace the Ford "Thick Film Integrated IV" ignition module.  It is a T20 torx bit for use on 7/32" hex or 5.5 mm retaining bolt.  You can also use a 1/2" wrench for added torque.

Instructions:

1. Remove distributor from vehicle and locate ignition module.
2. Use module tool to remove the two module screws. Use 1/2" open end wrench for extra torque.
3. Disengage module per manufacturer instructions
4. To install module, carefully position module on the mounting flange engaging the three connector pins. Use module tool to torque module screws to 15-35 inch pounds.