ST-64 UPSTREAM INJECTOR 1.5-4.0 GPM

High pressure injection. If you like the way soap is applied at self serve car washes, this accessory is for you. It allows your pressure washer to apply soap the same way. The ST-64 injector is designed to introduce detergents into the water system upstream from the pump for high pressure application. An adjustment screw sets the orifice to the flow of your pump. The "on-off" plunger is then used to control the injection.

When using this injector, the operator should consider the types of chemicals used. Pump damage can occur if acids or other harsh chemicals are used. Easy to install, use, and maintain.

Maximum Pressure: 140 PSI. Maximum Temperature: 160 degrees F.

INSTALLATION AND OPERATION

1. Connect the water supply hose to the female inlet on the injector.
2. Connect the male threads of the injector to the garden swivel fitting on the pressure washer.
3. With the plunger in the "off" position, turn on the water supply and operate the pressure according to its operations manual.
4. Turn the plunger to line the notch up with the shoulder bolt. Press the plunger down and turn it clockwise to lock "on."
5. With the pressure washer operating, the trigger gun open, and the chemical line submerged, use an 1/8" hex wrench to adjust the screw down until chemical is being siphoned. Caution: Do not over adjust the screw to a point of pump cavitation. Keep siphon hose submerged to prevent air intake.
6. Wehn not using chemical, turn the plunger line to the notch up with the shoulder bolt. Pull the plunger up to the "off" position. If desired, turn the plunger to lock off.

NOTE: Usually after the inital setting, the injector will not need aditional adjustment, however, different elevations or inlet water pressures may require a different setting. Simply repeat step #5 as needed, adjusting the screw down or up for proper setting

Thank you for browsing our selection of pressure washers, steam cleaners and accessories.

We have the tools you need to effectively use and maintain your pressure washer.  Quick connect and rotating turbo nozzles are available in various sizes and configurations.  It's important to use the proper size nozzle for your pressure washer.  Nozzles are sized by looking at the PSI and GPM of your pressure washer.  Quick connect nozzles make it easy to change spray patterns or replace nozzles when they are bad while using the same spray wand.

Pressure washer hoses and hose reels will help you reach your work area, and specialized spray guns with different angles and lengths of wands will make certain jobs easier.

To keep your pressure washer working properly, routine parts and maintenance could be required.  Pressure washer pumps, unloaders, and motors should match the specifications of your particular machine.  Hot pressure washers and steam cleaners require additional components like burners, ignitors, and fuel pumps to allow them to heat the water.

There are a number of different accessories for your hot or cold pressure washer to clean different areas.  Surface cleaners are great for cleaning large areas like parking lots, gas stations, industrial facilities, and school yards.  Duct cleaners are designed to clean trash-chutes, vents, ducts, restaurant hoods, tanks and more. Wet sand blasters can be used on various surfaces to remove most coatings down to white metal, for graffiti cleaning, or paint surface preparation.